|
|
Levelogger NPT Adaptor
Using Your Levelogger NPT Adaptor (#108549)
Note: |
The Levelogger NPT Adaptor is not recommended for pressures in excess of 30 psi. (66 ft. (20 m) of water column). |
-
The compression fitting nut may have to be loosened before the Levelogger is inserted.
-
Slide the Levelogger into the Compression Fitting, leaving approximately 1/4" of Levelogger Edge body exposed above the Compression Fitting.
-
Tighten the Nut 1-1/4 turns past finger tight for a proper seal.
-
Thread the 1/4" NPT Connector into a Female NPT connection until finger tight.
Note: |
To connect a Solinst Direct Read Cable and/or a Leveloader , simply unthread the Top Cap of the Levelogger and thread on the Connector Cable. |
 |
 |
| NPT Adaptor with Levelogger Installed and Connection to Direct Read Cable |
NPT Adaptor with Levelogger Installed |
® Solinst is a registered trademark of Solinst Canada Ltd.
|
