CMT Multilevel System Pre-installation Requirements

Please complete this form to verify that proper consideration has been given to design and borehole specifications for each CMT Multilevel System to be installed. (CMT tubing 1.7” OD, Guide Point Port 1.75” OD, Guide Point Port with Anchor 3.75” OD).

1/

Minimum information required for effective design of the CMT Multilevel System:

Accurate borehole depth

___________________________________________

Borehole Angle

___________________________________________

Depth to which CMT System is to be installed

___________________________________________

Borehole geology

___________________________________________

Drilling Method

___________________________________________

Casing size (minimum ID)

___________________________________________

Depth to base of well casing

___________________________________________

Number of Monitoring Zones

___________________________________________

Approximate Depth to Static Water Level

___________________________________________

Expected Maximum Pressure Heads at each Port location

___________________________________________

Site Conditions (eg. dry field, bush, swamp, paved, etc.)

___________________________________________

Any special surface requirements for completion of installation (eg. flush mounted, angled, etc)

___________________________________________

Solinst can assist the client in the design and component selection for the CMT Multilevel System based on the above requested information, but final design and installation details remain the responsibility of the purchaser.

2/

Ensure that these additional items are available on site during installation:

CMT Installation Toolkit (as shown below)

Measuring tape

Hacksaw

Marking pen or wax pencil

Model 103 Tag line for checking backfill depths

Model 101M or 102 Water Level Meters

At least two client representatives to supervise and assist with installation. Solinst can provide a technician to assist with the installation upon request.

Support stand (if purchased separately)

Adjustable wrench