Complete Table of Contents

CMT Multilevel System Pre-installation Requirements

a)Minimum information required for effective design of the CMT Multilevel System


b) Ensure that these additional items are available on site during installation


 

Introduction

 

Preparation

 

Assembling Standard CMT Multilevel Systems

1. Marking and Cutting the Tubing

2. Step 1)Uncoil Tubing
   

3. Step 2)Indicate Ground Surface on Tubing
   

4. Step 3)Locate Channel 1 Identifier
   

5. Step 4)Mark Monitoring Port 1
   

6. Step 5)Mark Port 1 for Port Cutting Guide
   

7. Step 6)Mark all Ports and Cut Tubing at Deepest Port
   

8. Step 7)Complete Design
   

top

9. Cutting the Outer Ports and Vent Holes

10. Step 8)Install the Port Cutting Guide
    

11. Step 9)Use Cutting Bolts to Cut Holes
    

12. Step 10)Cut Panel Between Upper Two Port Holes
    

13. Step 11)Insert Expansion Plug
    

14. Step 12)Install the Well Screen
    

15.  Installing Oetiker Clamps
    

16. Step 13) Line-up Port Cutting Guide
    

17. Step 14)Create Port 2 Opening
    

18. Step 15)Finish Constructing Port 2
    

19. Step 16)Construct Ports 3 to 6
    

20. Configuring the Bottom of the CMT Tubing (Zone 7)

21. Step 17)Insert Expansion Plugs
    

22. Step 18)Attach the Guide Point Port
    

23. Step 19)Install an Anchor
    

24. Attaching Tubing Centralizers

25. Step 20)Install Centralizers
    

26. CMT Placement

27. Step 21)Lower the CMT System
    

28. Step 22)Complete the Well Installation
    

29. Attaching the Standard Wellhead
    

30. Step 23)Attach the Wellhead
    

top

32.  

33. Optional Flow Control Monitoring Assembly

34.  

35. Monitoring Options

36.  Water Level Measurement
    

37.  Well Completion
    

38.  Sampling Methods
    

top