Complete Table of Contents

3-Channel CMT Assembly

CMT Multilevel System Pre-installation Requirements

a)Minimum information required for effective design of the CMT Multilevel System


b) Ensure that these additional items are available on site during installation


 

Introduction

 

Preparation

 

Assembling Standard CMT Multilevel Systems

1. Marking and Cutting the Tubing

2. Step 1)Uncoil Tubing
   

3. Step 2)Indicate Ground Surface on Tubing
   

4. Step 3)Locate Channel 1 Identifier
   

5. Step 4)Mark Monitoring Port 1
   

6. Step 5)Mark Port 1 for Port Cutting Guide
   

7. Step 6)Mark all Ports and Cut Tubing at Deepest Port
   

8. Step 7)Complete Design
   

top

9. Cutting the Outer Ports and Vent Holes

10. Step 8)Install the Port Cutting Guide
    

11. Step 9)Use Cutting Bolts to Cut Holes
    

12. Step 10)Cut Panel Between Upper Two Port Holes
    

13. Step 11)Insert Expansion Plug
    

14. Step 12)Install the Well Screen
    

15.  Installing Oetiker Clamps
    

16. Step 13) Line-up Port Cutting Guide
    

17. Step 14)Create Port 2 Opening
    

18. Step 15)Finish Constructing Port 2
    

19. Step 16)Construct Port 3
    

20. Configuring the Bottom of the CMT Tubing (Zone 7)

21. Step 17)Insert Expansion Plugs
    

22. Step 18)Attach the Guide Point Port
    

23. CMT Placement

24. Step 19)Lower the CMT System
    

25. Step 20)Complete the Well Installation
    

26. Step 21)Attach the Wellhead
    

27. CMT Installation with Sand and Bentonite Cartridges

28.  Introduction
    

29.  Installation Design Example
    

30.  Preparation
    

31.  Installation
    

32.  Port Assembly
    

33.  Installing Sand Cartridges
    

34.  Installing Spring Cartridges
    

35.  Installing Pre-formed Bentonite Cartridges
    

top

37. Monitoring Options

38.  Water Level Measurement
    

39.  Well Completion
    

40.  Sampling Methods
    

top