Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Home Products Contact Us About Downloads Papers & Info Tradeshows Español Links News

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Solinst Telemetry Systems

Model 9100 STS / Model 9200 RRL - Solinst Telemetry Systems


Alarm Settings

An e-mail alarm notification will be sent automatically to the Home Station, if a non-communication or low battery condition is detected at an STS or RRL Remote Station, when a reading is taken. The Home Station then sends out email alerts, as set up in the software.

High, low and percent change alarms can also be set for any monitored parameter (e.g. water level, temperature, rainfall, or conductivity).

solinst telemetry systems Water level alarms Remote monitoring Alarm notifications sts power supply sts power requirements rrl power requirements rrl power supply solinst telemetry system power requirements solinst remote radio link power requirements sts remote firmware updates image
E-mail Alarm Notification

 

Power Supply

Solinst Telemetry Systems are designed to avoid power issues. Each STS comes with a 12V battery that can last up to 12 months before replacing or recharging, depending on reporting frequency. The low power electronics of an STS are designed to only use power when there is a scheduled transmission of data, and very little power when it is in standby mode. Power requirements at RRL Remote Stations are also kept to a minimum. Each RRL Station is powered by 6 replaceable lithium batteries. Solinst provides optional cables that enable solar power or direct AC mains connection as a power source, as well as a battery charging kit.

 

 

Automatically receive remote system diagnostics at your Home Station PC

solinst telemetry systems Water level alarms Remote monitoring Alarm notifications sts power supply sts power requirements rrl power requirements rrl power supply solinst telemetry system power requirements solinst remote radio link power requirements sts remote firmware updates image

 

 

System Diagnostics

The STS and RRL are very reliable systems, which require minimal maintenance.

To help simplify system diagnostics, each data report to the Home Station includes System information. This information can help prevent data disruptions by providing the battery level, modem operation, signal strength and Levelogger status. A communication test can also be performed between the Home Station and a Remote Station, and Leveloggers.

STS Remote Firmware Updates

If new firmware becomes available, a firmware update can be performed from the Home Station using the update utilities supplied with the STS Software. New firmware is made available free via the Solinst website
(http://www.solinst.com/ Downloads/).

STS Systems also allow modem parameters to be reset remotely from the Home Station and changes made to the report and sampling rates.

 

 

 

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player